Your garage door will not open, and the first thing most people blame is the opener. Often that is wrong. The opener is only the motor that starts the door moving. The springs carry the weight. Knowing which one has failed helps you describe the problem when you call, and it keeps you from doing something unsafe.
Who does what
A garage door is heavy. Springs are wound or stretched so that they balance that weight. With good springs, the door feels light and will stay where you leave it. The opener then only has to nudge it up and down.
When a spring fails, the opener is suddenly asked to lift the full weight of the door. Most cannot, and they are not meant to.
First, look without touching
Keep the door closed and stand inside the garage. You are only looking.
- Springs above the door: many doors have one or two springs wound around a bar just above the opening. A broken one shows a clear gap in the coil.
- Springs along the sides: other doors have long springs that run beside the upper tracks. A broken one hangs loose or is in two pieces.
- Cables: look at the thin steel cables at each side of the door. They should be tight and seated on their drums or pulleys. A slack or tangled cable points to a spring or cable problem.
- The door itself: see whether it sits level on the floor or has a gap at one corner.
Signs that point to a spring
- You heard a loud bang from the garage, even when no one was using the door
- The opener runs, the door lifts a little and then stops or goes back down
- The door looks crooked as it tries to move
- You can see a gap in the spring or a loose cable
- The door feels extremely heavy
Signs that point to the opener
- Nothing happens at all: no sound, no light, no movement
- The wall button works but the remote does not, or the other way round
- The door starts to close, then reverses and the opener light blinks
- The motor runs but the door does not move, and the springs and cables look fine
- The door stops short of the floor or does not open all the way, the same amount each time
Easy things to check on the opener side
- Is the opener plugged in, and does the outlet have power?
- Has the lock button on the wall control been switched on by mistake?
- Does the remote need a new battery?
- Are the two small sensors near the floor facing each other, with clean lenses and nothing in between?
- Has the manual release cord been pulled, so the door is no longer connected to the opener?
A door that will not close and reverses with a blinking light is very often a sensor that has been bumped out of line.
The balance test, with a caution
If you have looked closely and see no broken spring and no loose cable, there is one more check. With the door fully closed, pull the manual release cord. Lift the door by hand to about waist height and let go slowly, keeping your hands and feet clear.
- If it lifts without much effort and stays roughly where you left it, the springs are doing their job. The problem is likely on the opener side.
- If it is heavy, or it drops when you let go, the springs are weak or out of adjustment.
Do not do this test if you saw a broken spring or a loose cable, or if the door is stuck open. A door with a failed spring can fall.
What not to do
- Do not keep pressing the button. You can burn out the opener or bend the door.
- Do not loosen or adjust springs, cables, drums or the brackets at the bottom corners of the door. These parts are under strong tension.
- Do not pull the release cord while the door is open if you suspect a broken spring.
- Do not stand or walk under a door that is partly open and not moving as it should.
What to tell the repair company
A few details make the visit quicker.
- Whether the door is stuck open or closed
- Whether you heard a bang
- What the opener does when you press the button
- Whether the springs are above the door or along the sides
- Whether it is a single or a double door
If you are in Omaha, Papillion or Bellevue, call Curbside Garage Door Co. Tell us what you saw and heard, and we will come out and take it from there.